Avery Dennison SS Finisher - Manual (Page 11)

Users Manual SS Finisher Operation •••• 11
Ultra Sonic Power Supply
Caution
Only qualified technicians should service the power supply.
The ultrasonic attachment is made up of several components. They are the
power supply, the horn assembly and the connecting cable. In addition there is a
knife assembly with a changeable tool steel blade.
The power supply should be located next to the SS Finisher. This unit generates
electrical pulses at 35 KHz to the converter. All guards must be closed for the
Sonics to be activated. The power supply contains a "TEST" button, power
indicator light, Auto/MAN switch, Cutting and US-Time controls and a relative
power gauge.
SG3510 CT
100 LOAD 50
100
200
100
6
MS
10
9 8 7
0
5
4
3
2
1
US-TIME
6
MS
1
10
9 8 7
0
5
4
3
2
1
TEST
CUTTING-CONTROL
POWER
OVERTEMP
OVERLOAD
TUNING
AUTO MAIN
10
ULTRASONICS
TELESONIC
TEST 2 10 20
The Ultrasonic Power Supply is pre-programmed for the correct settings at the
factory. The following instructions describe how to check and change these
settings.
NOTE: The power supply is adjusted for proper operation at the
factory. DO NOT change any of the adjustments on the power
supply.