Avery Dennison SNAP 656 - Manual (Page 38)

32B • •• • Control Panel Operation Users Manual Model 656/636
language with the selection. Pressing the MODE / Down Arrow key will take the
user to the "PROTOCOL" screen. Pressing the EXIT / Up Arrow key will take the
user back to the "HOME" screen.
Warning: Mis-matched communication protocols may result in the inability to
communicate with the printer and / or loss of data.
P R O T O C O L : X X X X X X
N E W P R O T O C O L : Y Y Y Y Y Y
This screen follows the "LANGUAGE" screen. This screen allows the
communications protocol to be changed between the supported types. Use the and NO> keys to move between the supported protocols – RTS/CTS is considered
hardware handshaking and XON/XOFF is considered to be software. Pressing
ENTER will update the communications protocol with the selection. Pressing the
MODE/Down Arrow key will take the user to the "BAUD RATE" screen. Pressing
the EXIT/Up Arrow key will take the user back to the "HOME" screen.
B A U D R A T E : X X X X X X
N E W B A U D R A T E : Y Y Y Y Y Y
This screen follows the "PROTOCOL" screen. This screen allows the serial
communications speed to be changed. Use the keys to move
between the supported speeds – typical is 9600 dependent on serial communication
cable length. Pressing ENTER will update the communications speed with the
selection. Pressing the MODE/Down Arrow key will take the user to the "CHANGE
DATE AND TIME" screen. Pressing the EXIT/Up Arrow key will take the user
back to the "HOME" screen.
C H A N G E D A T E A N D T I M E
0 3 / 1 4 / 0 0 1 2 : 0 5 P M
This screen follows the “BAUD RATE” screen. This screen allows the system date
and time to be changed. When this screen appears, the first digit of the month will be
blinking. (The date is shown in US format, MM/DD/YY.) Pressing the NO> keys will change the digit up and down respectively. Pressing ENTER will
move to the next digit. Only the digits and the A or P in AM or PM can be changed.
When all changes are complete, pressing the MODE/Down Arrow key will take the
user to the “INKSAVE ENABLE/DISABLE” screen, and pressing the EXIT/Up
Arrow key will take the user back to the “HOME” screen. If an illegal date or time is
entered, this screen will be re-displayed with the original date or time. A valid date
and time must be entered before the user can go on.
I N K S A V E I S E N A B L E D
P R E S S E N T E R T O D I S A B L E
OR
I N K S A V E I S D I S A B L E D
P R E S S E N T E R T O E N A B L E
This screen allows ink save to be enabled or disabled. Ink save is an option that is
available on certain models. It must be enabled in the format to operate. If ink save
is enabled in the format, it can be disabled using this screen. Pressing ENTER will
toggle from ENABLED to DISABLED and vice versa. Pressing the MODE/Down
Arrow key will take the user to the "CUTTER ENABLE/DISABLE" screen.
Pressing the EXIT/Up Arrow key will take the user back to the "HOME" screen.