Avery Dennison SNAP 656 - Manual (Page 32)

26B • •• • Control Panel Operation Users Manual Model 656/636
PRINT/CUT POSITIONS
P R E S S E N T E R F O R
P R I N T / C U T P O S I T I O N
This screen follows the "BATCH ID / BATCH QTY" screen if there are batches to
be printed; otherwise it follows the "READY FOR BATCHES / MODEL DPI" home
screen.
Pressing ENTER will take the user to the "PRINT / CUT POSITIONS" screens.
Pressing the MODE / Down Arrow key will take the user to the "PRINTHEAD
SETUP" screen. Pressing the EXIT/Up Arrow key will take the user back to the
"HOME" screen.
P R E S S E N T E R T O
P R I N T C H E C K O U T F O R M A T
This screen is the first screen under "PRINT / CUT POSITIONS". Pressing ENTER
will cause the printer to print the checkout format. The printer will setup to do the
checkout format and start printing. The front panel will remain on this screen so the
user can use the MODE/Down Arrow key to get to the printer adjustments. When the
EXIT/Up Arrow key is pressed the printer stops printing the checkout format and
goes back to what it was doing before the checkout was requested.
Pressing the MODE/Down Arrow key will take the user to the "PRINT POSITION”
screen. Pressing the EXIT/Up Arrow key will take the user back to the "HOME"
screen.
P R I N T P O S I T I O N
V A L U E : ± X X N E W V A L U E : ± Y Y
This screen follows the "PRINT CHECKOUT FORMAT" screen. This screen
allows the print position to be adjusted in the feed direction.
The buttons are used to change the new print value. The value is
displayed in a positive/negative format. The value ranges for XX and YY can be
from a -9 to a +9. Pressing ENTER will change the CURRENT PRINT value to the
NEW PRINT value. A more positive number will move the print to the right while a
more negative number will move the print to the left.
Pressing the MODE/Down Arrow key will take the user to the "CHANGE CUT
POSITION" screen. Pressing the EXIT/Up Arrow key will take the user back to the
"HOME" screen.
C H A N G E C U T P O S I T I O N
V A L U E : ± X X N E W V A L U E : ± Y Y
This screen follows the "PRINT POSITION" screen. This screen allows the cut
position to be adjusted. The buttons are used to change the new cut
value. The value is displayed in a positive/negative format. The value ranges for XX
and YY can be from a -9 to a +9. Pressing ENTER will change the CURRENT CUT
value to the NEW CUT value. A more positive number will move the cut to the right
while a more negative number will move the cut to the left.
Pressing the MODE/Down Arrow key will take the user to the "DOT SHIFT" screen.
Pressing the EXIT/Up Arrow key will take the user back to the "HOME" screen.