Avery Dennison SNAP 656 - Manual (Page 19)

Users Manual Model 656/636 Product Description • •• • 13B
Stock Support for blank or pre-printed fabrics, blank or pre-printed card stock and die cut blank or pre-
printed pressure sensitive
Interface AVERY DENNISON PCL via RS232 serial port - 9 pin D-shell
Control
Panel Push-button printer function with 2 Line x 24 Character International LCD Backlit Display
Dimensions 16.0" (406.4 mm) high x 27" (685.8 mm) wide
including stacker x 18.5" (469.9mm) deep
Weight 57 Lbs. ( 26Kg.)
Electrical 90-132 / 180-265 VAC 50-60Hz 10Amp Switch selectable
Temperature 41°F (5°C) to 104°F (40°C)
Humidity 5% to 90% non-condensing
Other
Features - Downloading of information while printer is operating
- Sequenced Fields
- Time/Date Stamping
- Life Counts
- Operator adjustable: strobe, cut position, print position, baud rate, and buffer size
- Error Detection of: stock out, ink out, print head open, full stacker, stacker jam, and print head
over-temperature
- Display: labels left to print in a batch, batch ID, total life inches, total life cuts
- Self Diagnostics
- Missed sense mark detection and correction
- Slot, Notches, Hole or Reflective registration detection
Ink Ribbon AVERY DENNISON standard thermal colors and widths
Options - SV-100 Barcode Verifier System
- Rewind Unit
- Reflective Sensor (Back of web)
- PcMate
- Formatter / PcMate Plus
- Spare Parts Kit
- International Hardware Kit
- Optional 4.25” Stacker
- Optional Downstacker
Optional 4.25” Stacker Specifications
• 4.25” Web x 1 ¾” Feed
• Will work on 636, 656 & 676
• Old machines may require the knife strut to be replaced with one that has a
mount hole – Part number 355018.
• Fabric and heat seal only - not for pressure sensitive or tags.
• Stack height dependent on material size and weight. (May not reach full stacker
height)
• Jam sensor will require relocating the LED to the center position for the 676 and
back set of holes for the 636 & 656.
• If changing from standard stacker to 4.25” stacker - the knife guard must be
changed to match the stacker being used.