Avery Dennison SNAP 656 - Manual (Page 37)

Users Manual Model 656/636 Control Panel Operation • •• • 31B
FEATURE SETUP SCREEN
P R E S S E N T E R F O R
F E A T U R E S E T U P
This screen follows the "LIFE COUNT / VERSIONS".
Pressing ENTER will take the user to the "FEATURE SETUP" screens. Pressing the
MODE/Down Arrow key will take the user to the "VERIFIER SETUP" screen.
Pressing the EXIT/Up Arrow key will take the user back to the "HOME" screen.
C U T T E R I S E N A B L E D
P R E S S E N T E R T O D I S A B L E
OR
C U T T E R I S D I S A B L E D
P R E S S E N T E R T O E N A B L E
This screen is the first screen of the "FEATURE SETUP". This screen allows the
cutter to be enabled or disabled. Pressing ENTER will toggle from ENABLED to
DISABLED and vice versa. Pressing the MODE/Down Arrow key will take the user
to the "EMULATION MODE" screen. Pressing the EXIT/Up Arrow key will take
the user back to the "HOME" screen.
E M U L A T I O N M O D E : N O N E
N E W E M U L A T I O N M O D E : 6 3 0
This screen follows the "CUTTER ENABLE/DISABLE" screen. This screen allows
the EMULATION MODE to be changed. Use the keys to move
between NONE, 630, and 650 modes. Pressing ENTER will update the emulation
mode with the selection after new emulation mode. Pressing the MODE/Down
Arrow key will take the user to the "DEFAULT TRANSFER TYPE" screen.
Pressing the EXIT/Up Arrow key will take the user back to the "HOME" screen.
D E F A U L T T R A N S F E R T Y P E
V A L U E : X X X N E W V A L U E : Y Y Y
This screen follows the "EMULATION MODE" screen IF emulation mode is
something other than none. This screen allows the DEFAULT TRANSFER TYPE to
be changed. This transfer type is used when the printer is in 630 or 650 emulation
mode. The 630 and 650 do not send valid 6X6 transfer types in their PCL code.
This default is used for those formats. Use the keys to change the
number value at the cursor position. Pressing ENTER will update the current value
with the new value (i.e. 053 for type 53). After ENTER is pressed on the last digit
the TRANSFER TYPE on the top line will be updated. Pressing the MODE/Down
Arrow key will take the user to the "LANGUAGE" screen. Pressing the EXIT/Up
Arrow key will take the user back to the "HOME" screen.
L A N G U A G E : X X X X X X
N E W L A N G U A G E : Y Y Y Y Y Y
This screen follows the "DEFAULT TRANSFER TYPE" screen. This screen allows
the front panel display language to be changed. Use the keys to
move between the supported languages on the printer. Any number of front panel
languages can be stored on the Flash Disk Module (dependent on available space). If
no additional languages other than the default are available on the printer XXXXXX
and YYYYYY will be the same value. Pressing ENTER will update the display