Avery Dennison ALS 350 - Manual (Page 74)

74
4 O
PERATION
4.4 S
ETTINGS IN THE EXTENDED MENU
ALS
350
450
Check setting
£ Call up the STOD function.
£ Set the value for STOD to „0“.
£ Confirm the value using the ENTER key and exit the
function.
£ Press the FEED key.
– A label is dispensed.
– The leading edge of the next label should rest exactly
on the dispensing edge [78].
£ Remove a single label from in front of the
sensor [79].
£ Press the FEED key.
– A label is dispensed [80A].
– The gap on the label ribbon should be automatically
compensated for [80B].
– The leading edge of the following label should rest
exactly on the dispensing edge [80C].
After the check:
– Check the label stop position (STOD); refer to
Page 55.
[78] The leading edge of the following label should rest on the dis-
pensing edge
[79] Remove a single label from in front of the sensor
[80] After pressing the FEED key:
A A label is dispensed
B The gap on the label ribbon should be automatically compen-
sated for
C The feed stops, the leading edge of the following label should
rest on the dispensing edge
A B C