Avery Dennison ALS 350 - Manual (Page 47)

47
4 O
PERATION
4.1 A
CTIVATION AND SHUT
-
DOWN
ALS
350
450
The machine can also be automatically initial-
ised after switch-on by using the INIT function:
£ In the standard menu, press the NEXT or PRIOR key
until INIT [39] is displayed on the operator panel.
£ Call the INIT function by pressing the ENTER key.
£ Press and hold the FEED key.
– The message AUTO appears on the operator panel.
– The machine slowly starts up and dispenses a label.
£ Release the FEED key once a label gap has passed
the photoelectric sensor at the dispenser head.
– If the initialisation was successful, „ON“ appears on
the operator panel.
Manually initialise the material
If automatic initialisation is not possible, it does
not generally mean there is a malfunction. Man-
ual initialisation is often required if:
– the proper label stop sensor is not installed.
– transparent labels are used.
– labels with only a slight difference of trans-
parency between label and backing material
are used.
– perforated or otherwise blocked out labels
are used [40].
Only by qualified calibration technicians:
£ Calling up the extended menu.
£ Input the label distance using the LPIT
function
£ Adjust the photoelectric sensor using the
CONT function.
£ Refer to chapter Operation – Settings in the
extended menu.
[39] INIT display on the operator panel
[40] A Label distance
B Photoelectric sensor
C Labels with block outs (perforations)
A
B C C