Avery Dennison ALS 350 - Manual (Page 57)

57
4 O
PERATION
4.2 S
ETTING AND MONITORING
ALS
350
450
4.2.3 Dispensing speed (VELO)
As a rule, the labelling speed must correspond to the
product speed. Depending on the operating conditions,
the labelling speed can also be set somewhat higher in
unique cases.
Prerequisites:
– The label stop position (STOD) is correctly set.
£ In the standard menu, press the NEXT [57A] or
PRIOR [57B] key until VELO [58] is displayed on
the operator panel.
£ Call up the VELO function by pressing the
ENTER [57C] key.
– The current speed is displayed on the operator pan-
el in m/min.
£ Change the labelling speed using the NEXT or
PRIOR key.
– Settings are possible in steps of 0.1 m/min:
Minimum: 0.5 m/min
Maximum: 55 m/min
£ Confirm the desired value using the ENTER key and
exit the VELO function.
Test the setting:
£ Remove the pressure roller unit at the dispensing
edge.
£ Start the system and only label one product.
– The labelling speed is too low if the product pulls the
label away from the backing material.
– The labelling speed is too high if the label on the
product has folds in it.
Automatic dispensing speed (optional)
If the automatic dispensing speed (APSF) is activated:
– Only display of the current speed using the VELO
function.
– Manual setting of the dispensing speed is not possi-
ble.
– For further information on the APSF function, see
chapter 4 Operation – Automatic dispensing speed
(APSF) Page 80.
[57] Symbols on the operator panel keys
A NEXT key
B PRIOR key
C ENTER key
[58] VELO display on the operator panel
A C B