Artesyn System Management Interface Based on HPI-B (Centellis CO 31kX-4100-2000-4410) (June 2014) - Manual (Page 84)

Using HPI-B
System Management Interface Based on HPI-B (Centellis CO31kX/4100/2000/4410) User’s Guide 84
4.6 Serial Over LAN Configuration
The ATCA-M100, ATCA-MF105, and SAM-1410 has the capability to automatically configure
the Serial Over LAN (SOL) feature as specified for IPMI V2.0. The SOL feature, for example,
allows you to view the boot process and the BIOS settings of a blade and to change BIOS
settings if necessary.
Whenever a front blade is discovered in the shelf, the ATCA-M100/ATCA-MF105/SAM-1410
checks whether the blade supports SOL. If it does support SOL, the ATCA-M100/ATCA-
MF105/SAM-1410 performs all configuration steps necessary to use the SOL feature.
This includes the following:
1. Configure an IPMI user
2. Configure user privileges
3. Configure LAN channel parameters
4. Configure SOL parameters
The most significant parameters to configure are the IP addresses of the LAN channels. These
are calculated according to the following formula:
TypeUnion.Analog.Default Default blower speed level
DefaultMode.Mode SAHPI_CTRL_MODE_AUTO
DefaultMode.ReadOnly SAHPI_TRUE
WriteOnly SAHPI_FALSE
Table 4-48 Fan Resource - Control State
SaHpiCtrlStateT Value
Type SAHPI_CTRL_TYPE_ANALOG
StateUnion.Analog Current blower speed level
Table 4-47 Fan Resource - Control (continued)
SaHPICtrlRecT Value