Artesyn System Management Interface Based on HPI-B (Centellis CO 31kX-4100-2000-4410) (June 2014) - Manual (Page 28)

Software Installation and Configuration
System Management Interface Based on HPI-B (Centellis CO31kX/4100/2000/4410) User’s Guide 28
ResourcePowerOnTimeout
A timeout after which
the resource FRU Power
State will be set to initial
state. This timer is
started soon after
executing the Power
On/hotswap operations
on the resource.
<0…N> [20000]
- 20000 ms
20000
clear_sel
Clear the SEL after
reading events from it
"yes | no" [yes]
– clear the SEL
No
– Do not clear the SEL
yes
RmcpEnable
Enables/disables the
RMCP server
"true | false" [true]
– enables the rmcp
server
false
– disables the rmcp
false
RmcpPort
Port on which RMCP
service runs
Standard port
[623] 623
RmcpMaxConnection Maximum number of
connections active.
After this count is
reached, any new
connections are
rejected.
<0…N> [10] – 10 connections 10
RmcpConnectionTimeout
RMCP connection
timeout
<0…N> [60000]
- 60000 msecs
60000 msecs
RmcpSessionTimeout
RMCP Session Timeout
<0…N> [60000]
- 60000 msecs
60000 msecs
RmcpPefAlerting
RMCP PEF alerting
"true | false" [true]
- supports PEF alerting
false
- does not support
false
RmcpPerMsgAuth RMCP per msg
authentication
"true | false" [true] - authentication
supported
false
RmcpPrivLimit
Privilege needed for
using RMCP service
"callback |
user | operator
| admin"
[admin]
- highest privilege
admin
RmcpAllowedAuthsCallback
Allowed authentication
mechanisms for
privilege level 'callback
"none | md2 | md5
| straight" "[none, md2, md5,
straight]" none
RmcpAllowedAuthsUser
Allowed authentication
mechanisms for
privilege level 'user
"none | md2 | md5
| straight" "[none, md2, md5,
straight]" none
RmcpAllowedAuthsOperator
Allowed authentication
mechanisms for
privilege level 'operator
"none | md2 | md5
| straight" "[none, md2, md5,
straight]" none
RmcpAllowedAuthsAdmin
Allowed authentication
mechanisms for
privilege level 'operator
"none | md2 | md5
| straight" "[none, md2, md5,
straight]" none
Table 2-5 Plugin Specific Parameters (continued)
Tag Description Allowed values Default in Config. file Built-in Default