Artesyn System Management Interface Based on HPI-B (Centellis CO 31kX-4100-2000-4410) (June 2014) - Manual (Page 21)

Chapter 2
System Management Interface Based on HPI-B (Centellis CO31kX/4100/2000/4410) User’s Guide 21
Software Installation and Configuration
2.1 Overview
This section describes how to set-up HPI-B daemons and clients and how to install all files
needed to develop client applications. Generally, all files are delivered in the form of RPMs. The
content of an RPM is reflected in its naming scheme.
The following table lists all RPM files needed to run clients and for their development. The
placeholder "architecture" stands for the supported CPU architecture of the respective blade
where the client is to run and can be any of the following:
 x86
Intel IA-32 bit blades
 x86_64
Intel IA-64-bit blades
 ppc_
PowerPC based blades
The files required for the HPI-B daemon come as part of the ATCA-M100/MF105/SAM1410
software which is delivered in the form of the following three RPM files.
Table 2-1 RPM Files for HPI-B Clients
RPM File Name Description
bbs-hpib--
1.-
-.rpm
This RPM is the HPI-B base package. It contains shared
libraries to be used by HPI-B clients and daemons, as well as
compiled example applications and client configuration
files. This package is required both by HPI-B daemons and
clients.
bbs-hpib-daemon--
1.-
-.rpm
This RPM contains all files which are related to the HPI-B
daemon: executables, libraries and configuration files.
Table 2-2 RPM Files for ATCA-M100
RPM File Description
cross-atca-m100-u-boot-
-1.noarch.rpm
U-boot loader