Artesyn System Management Interface Based on HPI-B (Centellis CO 31kX-4100-2000-4410) (June 2014) - Manual (Page 37)

Chapter 3
System Management Interface Based on HPI-B (Centellis CO31kX/4100/2000/4410) User’s Guide 37
Developing Applications
3.1 Overview
This chapter describes how to develop applications that make use of the HPI-B library.
Depending on the CPU architecture of the target system where you want to run your HPI-B
application and on the operating system, different RPM files are delivered which contain
include files and static libraries needed for the application development. The naming scheme
used for these files is as follows: bbs-hpib-devel--1.-
-.rpm
In order to run your HPI-B clients, you furthermore need to install the HPI-B client base package
applicable to the blade where the client is running. See
Setting Up HPI Clients on page 30 .
The HPI-B client base package contains compiled example applications which illustrate the use
of HPI-B controls. For these example applications the source codes and an example make file
are available as well. You may want to use the source code and the make file as a starting point
for developing your own applications. For further details refer to
Appendix A, Example
Applications, on page 95 .
3.2 Building the Application
If your development system is based on the same operating system/CPU architecture
environment as the target system, then you can simply install the RPM files on the target
system. If the development system is based on another operating system/CPU architecture
environment and you consequently intend to do cross-compilation, then the RPM files should
be converted to the cpio format and then extracted, using the standard Linux rpm2cpio
tool.
In order to do this, you would for example enter the following at the command prompt:
1. cd
2. rpm2cpio | cpio -id