Artesyn System Management Interface Based on HPI-B (Centellis CO 31kX-4100-2000-4410) (June 2014) - Manual (Page 30)

Software Installation and Configuration
System Management Interface Based on HPI-B (Centellis CO31kX/4100/2000/4410) User’s Guide 30
2.3 Setting Up HPI Clients
This section describes how to install/configure HPI clients on node blades.
PowerOnSequencing
To enable/disable
power on sequencing.
Specific feature of M100
shelf manager
<0,1> [1]
– enable
0
– disable
1
PowerBudgetComputation
Power budget
computation
<0,1> [1]
- Follow the Power Budget
algorithm before allocating the
power
0
- No power budget algorithm
is followed
1
HPI_OEM_DISCRETE_SENSOR_
DEF_SEVERITY
HPI-B Daemon will set
the severity for the HPI
events of non-threshold
sensors based on the
value configured for this
tag.
Note: If this tag is set to
3, then change the
OPENHPI_LOG_ON_S
EV
tag to
"INFORMATIONAL"
instead of "MINOR" so
that it logs events of
"INFORMATIONAL"
severity also into DEL.
<0,1,2,3> [3] - informational
0
- critical
1
- major
2 - minor
Note: Commented by default,
Please uncomment in the
config file for the tag to take
effect.
0 - critical
daemon will
assign the
default "critical"
severity
for the events of
non-threshold
sensors
(discrete/OEM)
SOL and cooling related options are not described in this table. For more information on this,
refer to
Cooling Management on page 73 and Serial Over LAN Configuration on page 84 on page
96.
Table 2-5 Plugin Specific Parameters (continued)
Tag Description Allowed values Default in Config. file Built-in Default