AMETEK XBT Series - Manual (Page 51)

Remote Interface Protocol and Package Mode
How to enable or disable DHCP status:
CONT:DHCP ON ==> enable DHCP
CONTROL:DHCP 1 ==> enable DHCP
CONT:DHCP 0 ==> disable DHCP
CONTROL:DHCP OFF ==> disable DHCP
How to get the IP address:
CONT:IP? ==> return the IP address
CONTROL:IP? ==> return the IP address
How to set the IP address:
CONT:IP 192.168.10.1 ==> set up the IP address for XBT32-3FTP
CONTROL:IP 192.168.10.1 ==> set up the IP address
5.5 Rules of Status Definition
byte 0: bit 7 channel 3 on/off status
bit 6 channel 2 on/off status
bit 5 channel 1 on/off status
bit 4 channel 3 OVP setting flag
bit 3 channel 2 OVP setting flag
bit 2 channel 1 OVP setting flag
bit 1 channel 3 OCP setting flag
bit 0 channel 2 OCP setting flag
byte 1: bit 7 channel 1 OCP setting flag
bit 6 output mode status; 0: single output 1: multi-output
bit 5 power on status,0:output off,1: rember pre-setting
status
bit 4 hot-key flag
bit 3 serial output mode
bit 2 parallel output mode
bit 1 track output mode
bit 0 beep trigger flag
M370187-01 Rev J
5-17