AMETEK XBT Series - Manual (Page 36)

Remote Interface Protocol and Package Mode
Note:
All commands must end with the and . And there must be a
space between the command and the parameter.
For example, to set the GPIB address of 10 to a XBT32-3FTP . The command
line is as follows:
ADDR 10
Note: The and are not presented in the following examples and
command descriptions. However, they must be added to the end of each
command when coding.
5.3 Error Message List
The SCPI maintains an Error/Event Queue as defined by SCPI. The queue holds
up to 10 errors and events. It is queried by using the status:error? command
which reads in a First In/First Out (FIFO) manner. The read operation removes
the entry from the queue. The *CLS command will clear all entries from the
queue.
Following is a list of error messages and their descriptions:
Error Description
===========================================================
-000
No error
-002 GET not allowed
-003 Parameter not allowed
-005 Command Header Error
-010 Numeric data error
-011 Invalid character in number
-013 Too many digits
-014 Numeric data not allowed
-016 Invalid suffix
-020 Invalid character data
-030 Invalid expression
-035 Macro parameter error
-056 Timer currently running
-058 Timer syntax error
5-2
M370187-01 Rev J