AMETEK XBT Series - Manual (Page 24)

Operation
3-4 M370187-01 Rev J
rotary + CLEAR again.
2. TRACKING: The initial value is OFF, switch to ON by pressing the rotary.
The CH2 will have the same voltage and current setting as
the CH1.
3. OVP setting: Over voltage protection. Press the rotary to enter OVP
Configuration. Press “CH” to select CH1/CH2/CH3. Use the
number keys to input the OVP value; press rotary (Enter) to
“set” (save) the value just input. Press ON/OFF to enable or
disable OVP.
4. OCP setting: Over current protection. Press rotary to enter OCP
Configuration. Press “CH” to select CH1/CH2/CH3. Use the