AMETEK XBT Series - Manual (Page 28)

Operation
3-8 M370187-01 Rev J
enable parallel output. The total output current is equal to
the output of both CH1 and CH2 when they are
parallel-connected.
12. Serial out: Serial output. The initial value is OFF. Press rotary to enable
serial output. The total output voltage is 4equal to the total
voltage of CH1 and CH2 when they are serial-connected.
13. Address: GPIB address setting. Acceptable range is 1~31. Use the
numbers keypad to input the value for the GPIB address and
press rotary to save the settings.
14. Hot Key: Express function key to go directly to stored memory setups.
The initial value is OFF. Press rotary to turn on hot key. Press
any number key 0-9 to recall the settings stored in the