AMETEK XBT Series - Manual (Page 40)

Remote Interface Protocol and Package Mode
MEMory memory subsystem
[ n] select [n] page memory number, n range from 0
~ 99
:VSET[n] volt setting for channel n: 1 - 3
[ level] voltage level: 0 – 32V for ch1 and ch2, 0 – 15V
for ch3
:ISET[n] current setting for channel n
[ level] current level: 0 – 3A for ch1 and ch2, 0 – 5A for
ch3
:SERial? read back serial number
:PWD set up password
:PASSword
[ string]
the string must be less than 15 charsters
:PWD? return password
:PASSword?
:SAVE
store memory subsystem parameters
CONTrol control subsystem
:LCD
[ state/bool]
turn ON (1) or OFF (0) the LCD backlight
:FASTREQ ON/1 (enable) or OFF/0 (disable) fast output
mode
[ state/bool]
:HOTKey
enable/disable hotkey mode
[ state/bool]
:LOCK
enable/disable keypad and rotary lock
[ state/bool]
:MONItor
enable/disable monitor to send "status" & V/I
message (GPIB & Ethernet not supported)
[ state/bool]
:DHCP
select DHCP command
[ state/bool] enables/disables DHCP mode
:IP select IP command
[?/ xxx.xxx.xxx.xxx] return IP address or set IP address
:CHannel select channel
5-6
M370187-01 Rev J