AMETEK XBT Series - Manual (Page 34)

Operation Setting
4.3 Set OVP
Press “Config” to enter Configuration mode; turn rotary or press the ◄► keys to
move the cursor to OVP setting. Press rotary to enter OVP setting display. Press
“CH” to select channel to be set (CH1, CH2 or CH3), indicated by the location of
the asterisk (*). Press the ON/OFF key to turn on or off OVP. Use the number
keys to input the voltage. Press rotary to accept the OVP settings.
4.4 Set OCP
Press “Config” to enter Configuration mode; turn rotary or press the ◄► keys to
move the cursor to OCP setting. Press rotary to enter OCP setting display. Press
“CH” to select channel to be set (CH1, CH2 or CH3), indicated by the location of
the asterisk (*). Press the ON/OFF key to turn on or off OCP. Use the number
keys to input the current. Press rotary to accept the OCP settings.
4.5 Adjust Voltage
When output is on, adjust the voltage with the rotary control. First, press
◄ or ► keys to position the cursor at the value to be adjusted. Adjust the voltage
by turning the rotary. To change channels, press the “CH” key. This provides a
convenient testing tool when observing the variation of the voltage.
4-2 M370187-01 Rev J