AMETEK XBT Series - Manual (Page 23)

2BOperation
(9) DISP:
Display key to select either the voltage/current or power/resistance readout
to show in the display screen.
(10) V(Voltage):
Sets voltage after value is input by either the Adjust control (2) or the
number keys (6).
(11) A(Current):
Sets current after value is input by either the Adjust control (2) or the
number keys (6).
(12) Config:
Configure mode for 16 items to be configured:.
1. Timer: The initial value is OFF. Press the Rotary Adjust/Enter Control
(rotary) to enter the timer configuration.
A. To set up the timer: Use rotary or ◄►keys to move the cursor to the
digit to be changed; use the number keys to input hours, minutes
and/or seconds. (HH:MM:SS).
B. Select CH1, CH2, or CH3 by pressing the CH key. .
C. Start Timer by pressing the ON/OFF key
D. Pause Timer by pressing rotary + CLEAR. Continue Timer by pressing
M370187-01 Rev J
3-3