AMETEK DCS-E 3kW Series - Manual (Page 50)

Advanced Operation Sorensen DCS-E Series 3kW Supplies
4-6 M362295-01 Rev C
R EPLACING THE O PTION B OARD ( WHEN REQUIRED )
12. Place the option board into its original location over the A2 circuit board.
13. Reinstall the mounting screws into the standoffs. Reattach any cables.
14. Reinstall the jackscrews with the nut driver.
15. Reconnect any external cables and connector.
R EPLACING THE C OVER
16. Place the cover in its original location.
17. Reinstall the eight (8) flathead Philips screws on the top of the cover, then tighten the
six (6) Philips screws in the side slots.
P OWERING U P
18. Reconnect the AC input connector. Turn the power supply ON.
4.2.4 Making J3 Connections
Some applications will use only the default factory connections on the J3 connector located on
the rear panel. Other applications will require replacing pin-to-pin connections or making
connections to external devices such as voltage sources, current sources, or resistances. Read
Section 2.2 Safety, and follow the procedures in this section whenever the rear panel
connector, J3, is to be reconfigured.
The steps to follow are: Dissipating stored energy
Making the connections
Powering up
Refer to the D ISSIPATING S TORED E NERGY and P OWERING U P steps in Section 4.2.3.
M AKING THE C ONNECTION
To make pin-to-pin connections:
1. Unsolder any pin-to-pin jumpers as required by the application.
2. Solder new connections using any appropriate single bus wire such as AWG 20 to 24.
To connect external source leads, resistance leads, or monitoring or sense lines:
3. Unsolder any jumpers as required by the application.
4. Solder leads to the specified pin using the recommended wiring and/or grounding point
for the application. Pin, wiring, and grounding specifications for particular applications
can be found in Section 4 Advanced Operation except for remote sensing
specifications that are in Section 3.3 Using Remote Sensing.