AMETEK DCS-E 3kW Series - Manual (Page 14)

Contents Sorensen DCS-E Series 3kW Supplies
iv M362295-01 Rev Cl
2.5.3 AC Input Connector Assembly .............................................................2-5
2.5.4 Strain Relief Assembly .........................................................................2-6
2.6 Initial Functional Tests .....................................................................................2-8
2.6.1 Power-on Check...................................................................................2-8
2.6.2 Voltage Mode Operation Check ...........................................................2-8
2.6.3 Current Mode Operation Check ...........................................................2-9
2.6.4 Front Panel Function Checks ...............................................................2-9
2.7 Load Connection ............................................................................................2-10
2.7.1 Load Wiring ........................................................................................2-10
2.7.2 Making the Connections.....................................................................2-11
2.7.3 Connecting Single Loads ...................................................................2-12
2.7.4 Connecting Multiple Loads .................................................................2-12
SECTION 3
BASIC OPERATION .................................................. 3-1
3.1 Introduction ......................................................................................................3-1
3.2 Standard Operation..........................................................................................3-1
3.2.1 Operating Modes and Automatic Crossover ........................................3-1
3.2.2 Local Programming Mode Operation ...................................................3-3
3.3 Using Remote Sensing ....................................................................................3-4
3.3.1 Connecting Remote Sense Lines.........................................................3-4
SECTION 4
ADVANCED OPERATION .......................................... 4-1
4.1 Introduction ......................................................................................................4-1
4.2 Configuring for Remote Programming, Sensing, and Monitoring.....................4-2
4.2.1 Programming, Monitoring, and Control Functions ................................4-2
4.2.2 Locating Jumpers, Switch, and Connector...........................................4-4
4.2.3 Resetting Jumpers and Switch.............................................................4-5
4.2.4 Making J3 Connections ........................................................................4-6
4.3 Remote Programming: Output Voltage and Current Limit..................................4-7