AMETEK DCS-E 3kW Series - Manual (Page 17)

Sorensen DCS-E Series 3kW Supplies Contents
M362295-01 Rev C vii
SECTION 7
APPLICATION NOTES ...............................................7-1
7.1 Battery Charging.............................................................................................. 7-1
7.2 Load Considerations........................................................................................ 7-1
7.2.1 Inductive Loads.................................................................................... 7-1
LIST OF FIGURES
Figure 1-1 DCS-E Series (3kW) Supply Front Panel Controls and Indicators............ 1-4
Figure 1-2 DCS-E Series (3kW) Supply Rear Panel Connectors and Terminals
(including optional internal GPIB Interface) .............................................. 1-5
Figure 2-1 AC Connector and Contacts ..................................................................... 2-5
Figure 2-2 Wire Preparation ....................................................................................... 2-5
Figure 2-3 Contact Orientation ................................................................................... 2-6
Figure 2-4 AC Wire Locations .................................................................................... 2-6
Figure 2-5 Strain Relief, as Supplied.......................................................................... 2-7
Figure 2-6 Strain Relief Assembly .............................................................................. 2-7
Figure 2-7 Connector J3 Default Configuration .......................................................... 2-8
Figure 2-8 Maximum Load Wire Length ................................................................... 2-11
Figure 2-9 Single Load with Local Sensing (Default) ............................................... 2-12
Figure 2-10 Single Load with Remote Sensing ........................................................ 2-12
Figure 2-11 Multiple Loads with Local Sensing ........................................................ 2-13
Figure 2-12 Multiple Loads with Remote Sensing .................................................... 2-13
Figure 3-1 Operating Modes....................................................................................... 3-2
Figure 3-2 Local Mode Default Configuration............................................................. 3-3
Figure 3-3 Connecting Remote Sense Lines.............................................................. 3-5
Figure 4-1 Connector J3 Pin Descriptions (for Remote Programming,
Remote Monitoring, and Sense Connections) .......................................... 4-3
Figure 4-2 Internal Jumpers and Switch (Default Settings Shown) ............................ 4-4
Figure 4-3 Programming Output Voltage and Current Limit Using the
REM/LOC Switch...................................................................................... 4-8
Figure 4-4 Programming Output Voltage with a 0-5 Vdc Source ............................... 4-9