KBC Networks Mesh2HT User Manual
Page 44
Mesh2HT User Manual
Manual-MESH2HT-Rev1311
Copyright © KBC Networks 2012
Page 44 of 59
www.kbcnetworks.com
Note:
a router symbol is used to represent the gateway. At this point, all nodes have the
same gateway IP address which is set to the gateway shown connected to the Node 1
Step 3:
A background image can be uploaded by selecting the
uploading the desired background image.
Note:
the image size is limited to 120kB and must be in a JPEG or GIF format. The
topology page will auto size to fit the uploaded image
Step 4:
Once an image has been selected, select the
approximately 20 seconds to upload and render the background image.
Step 5:
Move the Mesh2HT nodes around on the page to represent their physical
locations as shown below: