KBC Networks Mesh2HT User Manual
Page 40
Mesh2HT User Manual
Manual-MESH2HT-Rev1311
Copyright © KBC Networks 2012
Page 40 of 59
www.kbcnetworks.com
3.2.3.4
System: DEVICE MAINTENANCE
In this menu option the unit can be soft rebooted or reset to defaults.
Reboot: this performs a re-boot to the unit.
Reset to defaults: in this menu option the unit can be soft re-booted or reset to
defaults.
The default configurations are as follows:
LAN Configuration:
192.168.1.10
255.255.255.0
No Gateway IP
Interface Access Username:
admin
Interface Access password:
admin
Hostname:
AP
Local AP-ESSID:
KBC-Mesh2HT-2 (Radio 1)
KBC-Mesh2HT-1 (Radio 1)
Country Code:
USA, Canada (North America)
Select Country (all other countries)
Wireless Profile:
NA (IEEE802.11n & IEEE802.11a)
NG (IEEE802.11n & IEEE802.11g)
NY (IEEE802.11n & IEEE802.11y)
Channel Spectrum Width:
20/40M
Channel-Frequency:
set to auto-select
Transmit Power:
23 dBm (North America)
19 dBm (all other countries)
Local AP WPA Cipher:
AES
Local AP Pre-shared Key:
11111111
Long Range Parameters:
Enabled
RSSI LEDs:
LED1=10;
LED2=20;
LED3=30; LED4=40
Note:
if configurations (such as a LAN configuration or username/password) are lost, the
unit may need to be restored to defaults using the hard reset button on the bottom of
the unit case. If a restore is required, delete the old saved configuration file and create a
new one.