KBC Networks Mesh2HT - Manual (Page 37)

Mesh2HT User Manual
Manual-MESH2HT-Rev1311
Copyright © KBC Networks 2012
Page 37 of 59 www.kbcnetworks.com
3.2.2.6 Services: SNMP SETUP
The system is compatible with SNMP version 2.
3.2.2.7 Services: NTP SETUP
Use this section to set the system to network time protocol. The node must be connected
to the web for NTP set up to take place. Each node connected via the wireless Mesh link
can also be set to the same NTP by using the identical NTP server and gateway IP.
Select the time zone of the node deployment and click the ‘Enable NTP client’ check box
and select from the pull down menu for ‘Known Time Server’. Ensure that all nodes
connected are using the same Known Time Server. Select and
to initiate the NTP Set Up.
3.2.2.8 Services: TELNET SERVER
Telnet is default enabled for port 23, the default standard for Telnet. If desired for
security reasons, this option can be disabled. Telnet allows unit configuration settings
and readings through command line without the use of the embedded webpages.