Compile the design, Program a device, Compile the design –15 program a device –15 – Altera POS-PHY Level 2 and 3 Compiler User Manual
Page 27
Chapter 2: Getting Started
2–15
Compile the Design
© November 2009
Altera Corporation
POS-PHY Level 2 and 3 Compiler User Guide
Preliminary
10. When you have entered the required information for your new testbench, click
OK
in the New Test Bench Settings window.
11. Click OK in the Test Benches window and then click OK in the Settings window.
12. On the Tools menu, point to Run EDA Simulation Tool and click EDA RTL
Simulation
. The simulation now begins with your chosen simulation tool.
Compile the Design
You can use the Quartus II software to compile your design. Refer to Quartus II Help
for instructions on compiling your design.
Program a Device
After you have compiled your design, program your targeted Altera device, and
verify your design in hardware.
With Altera's free OpenCore Plus evaluation feature, you can evaluate the POS-PHY
Level 2 and 3 Compiler before you purchase a license. OpenCore Plus evaluation
allows you to generate an IP functional simulation model, and produce a time-limited
programming file.
f
For more information on IP functional simulation models, refer to the
hapter in volume 3 of the Quartus II Handbook.
You can simulate the POS-PHY Level 2 and 3 Compiler in your design, and perform a
time-limited evaluation of your design in hardware.
Figure 2–16. Example of New Test Bench Settings for NativeLink