Altera POS-PHY Level 2 and 3 Compiler - Manual (Page 19)

Chapter 2: Getting Started 2–7
POS-PHY Level 2 & 3 Walkthrough
© November 2009 Altera Corporation POS-PHY Level 2 and 3 Compiler User Guide
Preliminary
8. Click Next.
9. Select the parity settings of the interfaces (see Figure 2–8 ).
1
If parity is used the polarity setting must be the same for all interfaces.
f
For more information on the parity settings, see “Parity Settings” on page 3–8 .
10. Click Next.
11. Choose the first-in first-out (FIFO) buffer settings (see Figure 2–9 ).
If you select the Fixed Burst option, you must also set the burst size by entering a
value in the Burst field. Data is then sent in bursts of the specified burst size only,
or in bursts containing an end of packet.
Figure 2–8. Select the Parity Settings
Figure 2–9. Choose the FIFO Buffer Settings