Pilz PSSu H PLC1 FS SN SD - Manual (Page 24)

4.2 Configuration in a browser
4 Configure PSS 4000 Diag Control
Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany
Telephone: +49 711 3409-0, Telefax: +49 711 3409-133, E-Mail: [email protected]
4-12
Display of remedy messages
Properties for show/hide, plus column layout, e.g.
NAME="RmdCol1" VALUE="Responsibility">:
 RmdCol N (N columns from 1 to 7)
– Values:
– "Responsibility"
– "Scope"
– "Description"
– "Location.Device"
– "Location.EquipmentID"
– "Location.Address"
– "Location.Description"
– "Deactivated" = Invisible column
Properties for assigning column widths, e.g.
NAME="RmdColWidth1" VALUE="120">
 RmdColWidth N (N columns from 1 to 7)
– Values:
– Column width in pixels
PSS4000 Diag Control Properties Split Window 2 Beispiel
INFORMATION
Please note the following with properties:
– Always state a value in all the columns under "RmdCol N or
in none of them.
– Each column should be assigned a unique value
– If you don't wish to use every value, the remaining columns
should be assigned the value "Deactivated" (see example).
– If the "RmdCol N " properties are stated, then all the "Rmd-
ColWidth N " properties must also be stated.