Vortech 2005-2010 Ford 4.6L 3v Mustang GT User Manual

Page 74

P/N: 4FU020-010 v6.2, 06-08-10

Install the MAF sensor and air filter to

the 180° duct. (See Fig. 13-h.)

Install the 180° duct and the MAF sen-

sor with filter to the inlet duct leading

to the Supercharger. (See Fig. 13-i.)

Clock the MAF exactly as shown.

(See Fig. 13-i.)

Secure the rear clamp at the inlet duct

union to the previously installed sup-

port bracket. (See Fig. 13-i.)

MAF (Mass Air Meter) (Non-Cooled

Kits Only) Harness Extension:

Locate the supplied wire and butt

connectors in assembly 4FU101-

001.

NOTE: Install the MAF sensor element so

the inlet of the sensor faces the air

filter. (See Fig. 10-h.)

13. AIR INLET ASSEMBLY, cont’d

Attach the 3/8" hose previously connected to the

passenger’s side valve cover, to the 1/4"NPT x

3/8" hose x 90° fitting installed in a previous step.

Attach the 1" bypass outlet hose to the 90° plastic

fitting and secure the hose with a #16 hose clamp.

Install the duct to the inlet of the supercharger and

secure in place with the clamps provided.

Locate and install a 4.0" x 2.0" long sleeve to the

inlet of duct 4FU012-010 and secure with two #64

clamps. (See Fig. 13-e.)

Remove the Factory MAF sensor element from

the top portion of the air filter housing.

Install the element using the 4mm hardware pro-

vided to the supplied MAF tube. (See Figs. 13-f,

13-g.)

Fig. 13-e

Fig. 13-f

Fig. 13-g

TO MAF

FACING

AIR

FILTER