Charge air cooler installation, Cont’d, Front of vehicle – Vortech 2005-2010 Ford 4.6L 3v Mustang GT User Manual
Page 52

P/N: 4FU020-010 v6.2, 06-08-10
©2010 Vortech Engineering, LLC
All Rights Reserved, Intl. Corp. Secured
30
8. CHARGE AIR COOLER INSTALLATION
(CHARGE COOLED KITS ONLY)
, cont’d
Fig. 8B-j | Viewed From Below
17. Locate the 3/4" x 150° molded rubber hose
(7U038-150). Connect the short end of the
3/4" x 150° hose to the lower port on the pre-
viously installed water cooler. Install one of
the provided 3/4" hose unions into the open
end of the 150° hose. Attach a length of 3/4"
hose approximately 24" between tthe hose
union and the previously installed water pump
discharge. Secure all hose connections using
the nylon ratchet clamps provided. (See Fig.
8B-j.)
2010 models will require the passenger side
air diverter to be trimmed where the power
steering cooler line passes through. Enlarge
the bottom of this notch 1-1/2˝ for 3/4˝ hose to
pass through
18. Attach a length of 3/4" hose approximatelly
48" long to the previously installed water
pump feed port and secure. Route the open
end of the installed hose toward the passen-
ger’s side shock tower. This hose will be
connnected in later step. (See Fig. 8B-h.)
WATER COOLER
HOSE TO
WATER
PUMP
3/4" x 150°
HOSE (7U038-
150)
3/4" HOSE
UNION
FRONT OF VEHICLE
B.
WATER COOLER ASSEMBLY INSTALLATION, cont’d
NOTE: The installation of this hose sec-
tion should maintain an “uphill”
routing wthout dips or kinks.