Vortech 2005-2010 Ford 4.6L 3v Mustang GT User Manual
Page 38

P/N: 4FU020-010 v6.2, 06-08-10
©2010 Vortech Engineering, LLC
All Rights Reserved, Intl. Corp. Secured
16
F.
Remove the two bolts that retain the factory
idlers to the front cover. Discard the idlers and
bolts. Replace the top idler with the 3.5"
smooth idler (4FU016-021) .875"OD x .663"ID
x .101" spacer and stud bolt provided. Replace
the lower idler with the 3.5" ribbed idler
(4FU016-041) .875"OD x .663"ID x .101" spac-
er and stud bolt provided. (See Fig. 6.1-c.)
G.
Using the appropriate pulley puller, remove the
factory power steering pulley and discard.
Replace with the supplied 8-rib power steering
pulley with the appropriate installer tool.
H.
Remove the A/C clutch retaining screws.
Carefully remove the clutch and set aside with
the hardware and small spacer located
between tip of A/C compressor drive shaft and
A/C clutch spline. Replace with the supplied
8-rib A/C pulley (4FR016-021), and secure
using the factory hardware and spacer.
I.
Remove the crank pulley retaining bolt.
Using the appropriate pulley puller,
remove the crank pulley and discard.
Install the supplied 8-rib crank pulley
using the factory retaining bolt. (Thread
locking compound must be applied to the
screw threads.)
J.
Loosely install the 8-rib drive belt provid-
ed using Fig. 6.1-c for belt route refer-
ence. Not all pulleys are installed at this
time.
6.1 PULLEY AND SPACER REPLACEMENT (Bullitt/V-Power/8-Rib Kits Only - All
others skip to step 6.2), cont'd
Fig. 6.1-c