Vortech 2005-2010 Ford 4.6L 3v Mustang GT User Manual

Page 27

P/N: 4FU020-010 v6.2, 06-08-10

Locate the factory oil sensor on the driver’s side

of the vehicle near the oil filter.

Remove the sending unit and set aside.

Locate the supplied 1/4"NPT street TEE fitting.

Install the TEE in the same location as the factory

sending unit with the 1/4" x –4 x 90° installed on

the TEE at the location noted. (See Fig. 2-a.)

Attach the stainless steel –4 hose to the –4 fitting

installed in the street TEE. (See Fig. 2-a.)

Route the hose away from hot, sharp or moving

parts and move to the top of the engine where it

will be attached to the supercharger oil feed.

Reinstall the factory sensor in the branch of the

TEE as shown. (See Fig. 2-a.)

Fig. 2-a

NOTE: The oil feed hose to the S/C will

be installed in a later step of the

installation. Temporarily cap the

open end of the hose to prevent

contamination to the inside of the

hose.

2. OIL FEED INSTALLATION (Engine oil-fed kits only. Applications with V-3

superchargers skip ahead to step 4.)