Ubiquiti Networks PowerBridgM - Manual (Page 16)

13
Chapter 3: Main Tab airOS ™ v5.5.4 User Guide
Ubiquiti Networks, Inc.
Stations
(Available in Access Point or AP‑Repeater mode only.)
This selection lists the stations that are connected to the
device.
The following statistics for each station are displayed in
the station statistics window:
Station MAC Displays the MAC address of the station.
This is a clickable link that will display additional station
information.
Device Name Displays the station’s host name. The
device name can be changed on the System tab.
Signal/Noise, dBm The Signal value represents the
last received wireless signal level, and the Noise value
represents the noise level.
Distance (Available if the Auto Adjust setting is enabled
through the Advanced Wireless tab > Advanced Wireless
Settings.) Displays the current distance between
devices in kilometers and miles for Acknowledgement
(ACK) frames. With Auto Adjust enabled, the device’s
auto-acknowledgement timeout algorithm dynamically
optimizes the frame acknowledgement timeout value
without user intervention.
TX/RX, Mbps The TX value represents the data rates, in
Mbps, of the last transmitted packets, and the RX value
represents the data rates, in Mbps, of the last received
packets.
CCQ, % This index evaluates the wireless Client
Connection Quality (CCQ). The level is a percentage value
for which 100% corresponds to a perfect link state.
Connection Time Displays the connection time of each
station connected to the device. The time is expressed in
days, hours, minutes, and seconds.
Last IP Displays the station’s last IP address.
Action Displays available options for this station. For
example, click kick to drop the connection to this station.
Refresh To update the information, click Refresh.
Station Information
Detailed information is displayed when you click a specific
MAC address:
• Station Displays the MAC address of the station.
• Device Name Displays the host name of the station.
• Product Displays the product name of the device.
• Firmware Displays the firmware version of airOS.
• Connection Time Displays the amount of time the
station has been connected to the device. The time is
expressed in days, hours, minutes, and seconds.
• Signal Strength (TX/RX) The values represent, in dBm,
the last transmitted wireless signal level and the last
received wireless signal level.
• Noise Floor Displays the current value (in dBm) of the
environmental noise (from interference) the receiver
hears on the operating frequency. airOS considers
the Noise Floor while evaluating the signal quality
(Signal-to-Noise Ratio SNR, RSSI). The value mean
depends on the signal strength above the Noise Floor.
• Distance (Available if the Auto Adjust setting is enabled
through the Advanced Wireless tab > Advanced Wireless
Settings.) Displays the current distance between
devices in kilometers and miles for Acknowledgement
(ACK) frames. With Auto Adjust enabled, the device’s
auto-acknowledgement timeout algorithm dynamically
optimizes the frame acknowledgement timeout value
without user intervention.
• CCQ The value represents the quality of the connection
to the AP. This index evaluates the wireless Client
Connection Quality (CCQ). The level is a percentage
value for which 100% corresponds to a perfect link state.
• airMAX Priority The airMAX Priority of this station’s
traffic in comparison to the other stations.
• airMAX Quality The airMAX Quality level is based on
a percentage value for which 100% corresponds to a
perfect link state.