Spectrum Controls 1734sc-IE2CH - Manual (Page 33)

Chapter 3: Configuring the 1734sc-IExCH for RSLogix 5000 3-11
User’s Manual Pub. 0300257-01 Rev. A
Instance: 225 Size: 50 Bytes (DNET 46 Bytes)
OFFSET FIELD TYPE BYTES
(same structure as Ch.0 above)
0x28 Notch Filter (All Channels) SINT 1
0x29 pad SINT 1
0x2A RTS (All Channels) INT 2
0x2C Hart Pass-Through Hold Time UINT 2
Table 3-2 (IE4CH Configuration Assembly)
Instance: 225 Size: 90 Bytes (DNET 86 Bytes)
OFFSET FIELD TYPE BYTES
0x00 – 0x11 Channel 1 Configuration STRUCT 20
+0x00 Low Engineering Channel 0 INT 2
+0x02 High Engineering Channel 0 INT 2
+0x04 Digital Filter Channel 0 INT 2
+0x06 Low Alarm Channel 0 INT 2
+0x08 High Alarm Channel 0 INT 2
+0x0A Low Low Alarm Channel 0 INT 2
+0x0C High High Alarm Channel 0 INT 2
+0x0E Reserved pad alignment bytes SINT 1
+0x0F Alarm Latch Channel 0 SINT 1
+0x10 Enable Hart Channel 0 SINT 1
+0x11 Alarm Disable Channel 0 SINT 1
+0x12 Reserved pad alignment bytes INT 2
0x14 Channel 1 Configuration
(same structure as Ch.0 above)
STRUCT
20
0x28 Channel 2 Configuration
(same structure as Ch.0 above)
STRUCT
20
0x3C Channel 3 Configuration
(same structure as Ch.0 above)
STRUCT
20
0x50 Notch Filter (All Channels) SINT 1
0x51 pad SINT 1
0x52 RTS (All Channels) INT 2
0x54 Hart Pass-Through Hold Time UINT 2
3.5.1 Channel Configuration
Low Engineering
The minimum scaled value that will be displayed when the analog input signal is at 4
mA. This feature is applied on a per channel basis.