Spectrum Controls 1734sc-IE2CH - Manual (Page 27)

Chapter 3: Configuring the 1734sc-IExCH for RSLogix 5000 3-5
User’s Manual Pub. 0300257-01 Rev. A
2.) Select the module type from the Select Module Type pop-up.
3.) Configure the remote Ethernet communication module.
3.3.3 Add the Generic Point IO Module
After adding the remote Ethernet communication module, the 1734 Generic Module must
be added. The following steps must be followed to add the 1734 Generic IO Module.
1.) Select a New Module for the I/O Configuration.
Name the module
Select the comm. format
Enter IP address of ENBT
Select the chassis size
Select electronic keying level
Click OK
Select the module revision
level
Select the remote Ethernet
communication module.
Click OK