Generalmusic wk1or - Manual (Page 87)

○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
80 Owner’s Manual
5. Press the PAGE again. The display will show this
The TEMPO/DATA keys control the Midi channel number .
6. Press ESCAPE key to exit “MIDI/GENERAL” mode.
To save changes made to the Performance, press and hold the STORE
PERFORMANCE key for a few seconds. Press ENTER to confirm and
save the changes.
If the changes are not saved, they will be lost as soon as a new Performan-
ce is recalled.
7. Play on WK1 Or keyboard to send MIDI data to the external expander.
The sounds coming from both WK1 Or and the expander can be heard
together.
CONTROLLING WK1 ORIENTAL FROM A MIDI ACCORDION
Connect the accordion MIDI OUT port to WK1 Or MIDI IN socket with a standard
Midi cable. To drive WK1 Or from your accordion, proceed as follows:
1. Set MIDI LOCK to ON (as explained in the MIDI/GENERAL chapter).
2. Set WK1 CHORD channel (as explained in the MIDI/GENERAL chapter)
to the accordion CHORD channel, or to the channel engaged by your
accordion to transmit chords ( midi accordions usually engage Ch.2).
3. Set WK1 Or tracks to the midi channels, using the table shown below.
4. Set COMMON channel to OFF.
5. Make sure that WK1 Or is set to ONE FINGER mode (refer to the
ARRANGE MODE instructions).
6. Extend the SPLIT point to the maximum setting allowed for the chords
(refer to the SPLIT chapter).
Note: If you wish to listen to WK1 Or sounds together with the melody
coming from your accordion, set the UPPER 1 sections (or UPPER1 and
UPPER 2 together) to the same midi channel that the accordion engages
for the right hand, or melody section (midi Accordions usually engage Ch.1
and/or Ch. 4).
You can store the setting you have obtained to one or more of the 63
Performances available. The entire set of Performances can be saved to the
Floppy Disk.
The MIDI channels in WK1 Or keyboard sections, must correspond to the
channels in the expander sections, (alternatively, set the expander
sections so that they correspond to WK1 Or sections).
4. Press the PAGE key to switch to MIDI CHANNEL mode and to the
relative tracks.
Schema per Fisarmonica MIDI
DRUM= Ch 10
BASS= Ch 3
ACC1= Ch 5
Acc2= Ch 6
Acc3= Ch 7 LOWER= Ch 2
UPPER2= Ch 1
UPPER1= Ch 1
COMMON= OFF
CHORD= 2
MIDI Common Channel : off
MIDI Chord Channel : off
4
5
6
7