Generalmusic wk1or - Manual (Page 33)

○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
26 Owner’s Manual
d) Modify the volume of the tracks.
Use the Function keys (F1…F9) to enter the desired track. The first
page will be shown in the display. Press the CURSOR key once: the
volume value will start blinking. Use the TEMPO/DATA key to modify
the volume.
e) Transpose the tracks.
Use the Function keys (F1…F9) to enter the desired track. Press the
CURSOR twice: the transpose value will start blinking in the dsiplay.
Use the TEMPO/DATA keys to raise or lower the pitch by a semitone.
f) Modify the effects.
The ON/OFF status of the REVERB and CHORUS functions, the
corresponding effect types and the relative overall effect volume can be
saved to the current Performance..
g) When the track is blinking, it is possible to modify each value in the
single section.
Use Page[ ]and[ ] keys to control the values.
PERFORMANCE VALUES
- VOLUME : (00/127) displays the track Volume.
- REVSEND: (00/15) the value indicates the amount of Reverb effect
in the track.
- CHOSEND: (00/15) the value indicates the amount of Chorus
(Modulation/Delay effect) in the track.
- TRANSP: (-24/+24). indicates the transpose setting.
- DETUNE: (-63/+63) influences the overall fine tuning: it moves by
1/64th of a semitone.
- PAN : (00/31 right 00/-31 left) moves the sound of the track to the left
or to the right.
By setting this value to the minimum with the TEMPO/DATA, keys, the
PAN mute message appears in the display; the sound is no longer heard
but the effects are still active in the track. In this case, you will only hear
the effect processed sound.
If the track is engaged by a Drumkit which already features a pan setting
the message PAN lock appears: in this case PAN is not active.
- VOLPED: (ON/OFF) enables or disables the Volume Pedal control on
the track (the Volume Pedal is optional and must be connected to the
rear panel jack socket).
- DAMPER: (ON/OFF) enables or disables the Damper Pedal control
on the track (the Damper Pedal is optional and must be connected to
therear panel jack socket).