Generalmusic wk1or - Manual (Page 78)

○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
Digital Signal Processor 71
1
2
3
4
5
DISABLING THE EFFECTS
You can disable the effects assigned to the current Performance at
any time.
• By pressing the REV/CHO key you will either enable (led ON) or
disable (led OFF) the DSP.
Controlling the Effect Send Level
The appropriate effect (Reverb or Chorus) effect can be set to each Perfor-
mance track independently.
REVSEND
Controls the REVERB level in each Performance track.
CHOSEND
Controls the CHORUS level in each Perforrmance track.
1. Select the track you wish to modify, using one of the two function
keys.
(Note: you must not be in Performance mode. Besides, Single Touch
Play must not be active).
2. The selected track will blink in the display, and the assigned Sound
will be shown in the 8-digit area. Press the Page key to enter the
track edit page.
3. Press the Page key repeatedly until you get to the RevSend o r
ChoSend page.
The value shown, between 00 and 15; indicates the amount of effect
assigned to the track.
4. Modify the value using the TEMPO/DATA keys.
5. Press ESCAPE to exit.
6. Press the STORE PERFORMANCE key for a few seconds and
confirm with ENTER to save the changes to the current Perfor-
mance.
Note : If you select another Performance, or recall the current one
before saving the changes, the Performance will be restored to the
previously changed settings.