Generalmusic wk1or - Manual (Page 73)

○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
66 Owner’s Manual
1
2
3
4
1
2
4
5
6
Quantize
Quantize function self-corrects errors in the recording Tempo. In other
words, small possible imperfections are trimmed and corrected, and
the beats are made homogeneous within a bar, according to the
established Quantize value.
1 . Select and playback the Riff you wish to correct, then press the
QUANTIZE key
The playback stops and the Riff, track and current quantize value are
shown in the display.
2 . Use the CURSOR key to move to the Quantize parameter, and the
TEMPO/DATA keys to select a new value.
3 . Press the Start/Stop key to listen to the corrected Riff.
4 . If you are satisfied with the corrections, press the ENTER key twice
to confirm.
If you wish to further improve the pattern, stop the execution by pressing
the Start/Stop key. Select a new quantize value and listen to the newly
modified riff agin. You can continue until the patterns sounds perfect.
Clear Note
If you detect that a Riff contains wrong notes, you can clear them. Up to
5 notes can be cleared at the same time from the recorded Riff.
1 . Select the Riff you wish to correct, then press the CLEAR key.
2 . Select the track you wish to modify by pressing the relative Function key.
In our example, the Drum track will be corrected by cancelling a few
notes.
3 . While the Riff is playng, check the beat counter and identify at what
point and which notes you wish to clear.
4 . Press the keyboard note you wish to cancel just a little below the
established point.
5 . Stop the pattern by pressing the Start/Stop key.
6 . To exit CLEAR mode, press the ESCAPE key twice.
Apply this procedure to any Riff you wish to improve.
LOWER
MEMORY
ARRANGE
ON/OFF FILL A FILLB /TAP
4
LOWER
MEMORY
ARRANGE
ON/OFF FILL A FILLB /TAP 4