Ditch Witch JT100AT - Manual (Page 137)

Systems and Equipment - 136
JT100/JT100 All Terrain Operator’s Manual
Driver/Loader Attachment
CMW
©
Drive Anchors
1. With drill frame at desired entry pitch, rotate ratchet
binders (2) to lower anchor plate until it rests on
ground.
2. Remove pull pins (1).
3. Ensure that anchor driver is attached to loader/
driver and slowly swing loader/driver boom to front
of drilling unit.
4. Attach anchor driver to auger shaft.
Moving parts could cut off hand. Keep hands away.
Turning shaft will kill you or crush arm or leg. Stay away.
NOTICE: If pull pins are not removed before
drilling, ratchet binders will be damaged.