Ditch Witch JT30AT - Manual (Page 193)

Complete the Job - 193
JT30 /JT30 All Terrain Operator’s Manual
Rinse Equipment
CMW
Rinse Equipment
Using Washwand
1. Connect the washwand at quick connect (2) at
rear of unit. Close valve to stop water flow.
Close valve (1) to shut off flow to spindle.
2. Spray water onto equipment to remove dirt
and mud. Some pressure might be needed to
remove dried mud from wrench area.
Pressurized fluid or air could pierce skin and cause injury
or death. Stay away.
To help avoid injury:
• Never use high flow when using washwand.
• Prime the drilling fluid pump before operating washwand. Failure to prime the drilling fluid pump will
cause flow fluctuations, which will make it difficult to control the washwand. For instructions, see
“Connect Fluid System” on page 102.
NOTICE: Do not spray water onto operator’s console. Do not spray water onto electrical center in
engine compartment. Electrical components could be damaged. Wipe down instead.