Ditch Witch JT30AT - Manual (Page 137)

Systems and Equipment - 137
JT30 /JT30 All Terrain Operator’s Manual
Electric Strike System
CMW
Voltage Test
1. Place voltage limiter on something insulated from ground and drilling unit (such as dry board or tire),
but near frame of drilling unit.
2. Clip one lead to frame.
3. Clip other lead to one voltage limiter mount.
4. Move simulator switch to "voltage" and press test button.
5. Watch screen and lights above display on strike system.
• ESID bar graph should show full bar.
• Alarm and strobe should turn on.
• ESID and STK LED should flash.
• ESID% and Voltage "Volts" should show 90-110%.
It is normal for simulator voltage levels to drift below strike level. When this happens, ESID bar should
show less than full and alarm and strobe should stop working. If the level drifts above strike level again,
light, ESID bar, and strobe should be turned on again.