Dolphin Peripherals 9500 - Manual (Page 92)

5 - 26 Rev C Dolphin® 9500 Series User’s Guide
Configuring Network Cards
To see the network cards installed on your terminal, tap Start > Settings > Connections tab > Connections > Advanced tab
(see page
5-17 ) > Network Cards.
Tap on an adapter to review its settings.
Use server-assigned IP address is selected by default; server-assigned IP addresses use DHCP. If you make any changes on
these tabs, you must tap OK to save the changes, then perform a soft reset to update the registry.
After you tap OK, the following message appears:
Tap OK again to save any changes.
For details about performing a soft reset, see Soft Reset (Warm Boot) on page 2-11. During the soft reset, the new registry entries
created by the changes can be read by the applications that need them.
Do NOT perform a hard reset (see Hard Reset (Cold Boot) on page 2-11) after modifying an adapter here. Hard resets return the
terminal to factory defaults.
!