Dolphin Peripherals 9500 - Manual (Page 232)

13 - 8 Rev C Dolphin® 9500 Series User’s Guide
Mobile Base Serial Connector
The following diagram displays the pin diagram of the serial connector of the bottom panel of the Mobile Base.
Note: Signals referenced are for a DTE device.
The Mobile Base connector is straight to the printed circuit board (PCB). The ninth pin sends 500mA at 5V power out. This can
power a peripheral device, such as a mobile printer, as long as that peripheral device can accept 500mA at 5V.
Configuring the Terminal for ActiveSync Communications
1. On the terminal, tap Start > ActiveSync > Tools > Options. ActiveSync opens displaying the PC tab.
2. In the Use this PC drop-down list, select the name of the host PC.
3. Select Sync with this PC during manual sync to indicate that the terminal syncs with the selected host PC when
synchronization is run from the terminal.
Pi n # Description
1 Interna l Jumpe r to Pi n 6
2 TXD
3 RXD
4 DSR
5 GND
6 DTR
7 CTS
8 R TS
9 5 VO LT OUT