ADLINK aTCA-N700 - Manual (Page 73)

aTCA-N700 SW Users Guide
６７
■ Obtain the SOL configuration parameters for a given channel.
ipmitool sol info
Figure 11-11 Get SOL Configuration Parameters Command
■ Change one of the following SOL Configuration parameters.
Session privilege level ( = privilege-level)
Character accumulate interval ( = character-accumulate-level)
Character send threshold ( = character-send-threshold)
Retry count ( = retry-count)
SOL Enabled status ( = enabled)
Retry interval ( = retry-interval)
Non-volatile bit rate ( = non-volatile-bit-rate)
Volatile bit rate ( = volatile-bit-rate)
ipmitool sol set
■ Establish an SOL session with the payload and enter the terminal mode. The
addr>, and parameters are can be changed at run-time
using the commands described above.
Figure 11-12 Testing Serial-over-LAN
■ You can terminate a SOL session entering “~.” from the terminal.