ADLINK aTCA-N700 - Manual (Page 54)

aTCA-N700 SW Users Guide
４８
BCM.0> stg remove 2 3
BCM.0> stg show 2
STG 2: contains 0 VLANs
** Delete STG2.
BCM.0> stg destroy 2
BCM.0> stg show
STG 1: contains 3 VLANs (1,3-4)
Forward: xe
BCM.0>
8.3.5. Mac configuration
Port static mac information is configured by ‘l2’ command.
Usage (L2): Usages:
l2 add [PortBitMap= or Port=] [MACaddress=]
[Vlanid=]
[Trunk=true|false] [TrunkGroupId=] [STatic=true|false]
[SourceCosPriority=true|false] [DiscardSource=true|false]
[DiscardDest]=true|false] [L3=true|false] [HIT=true|false]
[Replace=true|false] [CPUmirror=true|false] [MIRror=true|false]
[ReplacePriority=true|false] [RemoteLookup=true|false]
[MacBlockPortBitMap=] [Group=]
- Add incrementing L2 addresses associated with port(s)
l2 del [MACaddress=] [Count=] [Vlanid=]
- Delete incrementing L2 address(s)
l2 show [PortBitMap=
- Show L2 addresses associated with port(s)
l2 check [hit, valid, static]
- Check full L2 table for valid entries
l2 clear [Module=] [Port=] [MACaddress=]
[Vlanid=] [TrunkGroupID=] [Static=true|false]
- Remove all L2 entries on the given module, module/port,
VLAN, or trunk group ID
Some examples of mac configuration are shown below.
** Set mac = ’00:00:00:00:00:21’ for port xe0 in L2 table vlan 2.
BCM.0> l2 add pbm=xe0 mac=0x21 v=2 static=true
** Display L2 table.
BCM.0> l2 show
mac=00:00:00:00:00:21 vlan=1 modid=0 port=1/xe0 Static ReplacePriority
** Remove mac ‘00:00:00:00:00:21’ in L2 table.
BCM.0> l2 del mac=0x21 v=2
** Remove all mac information associated with vlan 1 in l2 table.
BCM.0> l2 clear v=1
L2: Deleting static and non-static addresses by VLAN