ADLINK aTCA-N700 - Manual (Page 39)

aTCA-N700 SW Users Guide
３３
6.3. Base Switch
The base port switch is managed by “robo” command. The usage is as the following.
=> robo
robo - Base Switch specific commands
Usage:
robo [command] ...
robo w show - show port stats of base switch
robo init - init forwarding function of base switch
robo close - close forwarding function of base switch
robo enable|disable - enable/disable base switch port(IMP port: >5)
robo sread - read base switch register
robo swrite - write base switch register
The base switch port status is monitored with a command in the following example.
=> robo show
Switch State: Managed (Forwarding)
Port Name STP Link Speed Tx(U) TX(B) Tx(M) Rx(U) RX(B) Rx(M)
========================================================================================
0 IPMC DIS Up 100(H) 0 0 0 0 0 0
1 LMP NOSTP Up 1000(F) 0 29 55 0 0 0
2 Front NOSTP Up 1000(F) 0 0 0 0 15366 4639
3 BaseB DIS Up 1000(F) 0 14 32 0 0 0
4 BaseA DIS Up 1000(F) 0 0 0 0 0 0
5 OctB DIS Down 1000(H) 0 0 0 0 0 0
- OctA DIS Up 1000(F) 0 0 0 0 0 0
The “robo” command in LMP U-Boot is equivalent to the command “nbm-robo” on the
LMP linux.