ADLINK aTCA-N700 - Manual (Page 68)

aTCA-N700 SW Users Guide
６２
10.2. ipmitool
The ipmitool program provides a simple command-line interface to the LMP. It features
the ability to read the sensor data repository (SDR) and print sensor values, display the
contents of the System Event Log (SEL), print Field Replaceable Unit (FRU) inventory
information, read and set LAN configuration parameters, and perform remote chassis
power control.
The command is;
[CMD] ipmitool
<…>
Table 10-1 ipmitool options
Option Description
sel list Shows the SEL log stored in a flash device on the monitor.
sdr Shows the sensor data on the monitor.
fru Shows the FRU information on the monitor.
Following is an example for ipmitool with sel list option.
root@aTCA-N700:~# ipmitool sel list
…
3dc | Pre-Init Time-stamp | FRU Hot Swap | Transition to M5 | Asserted
3dd | Pre-Init Time-stamp | FRU Hot Swap | Transition to M6 | Asserted
3de | Pre-Init Time-stamp | FRU Hot Swap | Transition to M1 | Asserted
3df | Pre-Init Time-stamp | OEM #0x11 |
3e0 | Pre-Init Time-stamp | OEM #0x13 |
3e1 | Pre-Init Time-stamp | FRU Hot Swap | Transition to M1 | Asserted
3e2 | Pre-Init Time-stamp | OEM #0x0f | State Asserted
3e3 | Pre-Init Time-stamp | OEM #0x10 | State Deasserted