ADLINK aTCA-N700 - Manual (Page 31)

aTCA-N700 SW Users Guide
２５
=>
setenv rootpath /tftpboot/aTCA-N700T/RFS/rootfs -> Set rootfs path information
=> setenv netdev eth0 -> For REV1 set netdev as eth0(mgmt port)
=>
setenv serverip 192.168.0.142 -> set NFS server IP address
=> setenv ipaddr 192.168.34.56 -> set my IP address
=> setenv gatewayip 192.168.0.1 -> set gateway IP address
=> setenv netmask 255.255.0.0 -> set netmask
=> run nfsboot
5.4. Booting via USB storage
To boot from a USB storage attached to the blade face plate connector with a pre-
programmed images on the storage, see the following example.
=> usb start
=> fatload usb0 0 $loadaddr kal
=> fatload usb0 0 $fdtaddr kad
=> fatload usb0 0 $ramdiskaddr kar
=> setenv bootargs root=/dev/ram rw console=$consoledev,$baudrate
ramdisk_size=460000
=> bootm $loadaddr $ramdiskaddr $fdtaddr